QCX5(MS-K)磁力启动器 QCX5(MS-K)Magnetic starter 一、适用范围 Application 　　本起动器适用交流50Hz或60Hz电压至660V、电流至95V，以下的电路中作为控制三相鼠笼式电动机之起动、停止及反向运转之用，具有体积小、安装方便之特点。它具有欠压和过载保护性能。 　　本起动器适用于在一般正常环境下使用，（不能防暴、防腐）本产品具有（带按钮、钮子、密封圈和不带钮等）品种，适用于湿热地区。技术数据：备装产品型号、规格、控制容量。 　　The starter is with the application of 50Hz or 60Hz AC voltage to 660V,current to 95A,The following circuit asthe contro l of three-phase squirrel cage,to Start,stop and reverse starting the moter.Which is with the smallvolume,installation convenience features.It has lost pressure and overload protection performance. 　 　The starter applied to the environment under normal use(with out explosion-proof,anti-corrosion).Theproducts have many kind of with buttons,button-sealed Circle and without button,etc.It is apply to hot andhumid area.Tec-hnical data:a model by loading products,specifications,capacity control.
	二、型号及含义 Types and meanings
	三、正常工作和安装条件 The normal working and installment conditions 1、周围空气温度：周围空气温度上限不超过+40℃，下限不低于-5℃，24h的平均温度不超过+35℃。 2、安装地点的海拔高度不超过2000m。 3、空气相对湿度，在周围空气温度为40℃时不超过50％，在较低的温度不可以有较高的相对湿度，最湿月的月平均最低温度为+25℃时，月平均最大相对湿度为90％，并考虑由于温度变化可能在产品表面产生凝露。 4、安装地点的环境污染等级为3级。 5、安装类别为III类。 6、安装条件：A.与垂直面的安装斜度不超过5° 　B.安装在无显著振动和冲击的地方。 1、Surrounding air temperatures:The surrounding air temperature upper limit does not surpass +40℃,the lower limit is not lower than-5℃,The average temperature does not surpass +35℃ in 24 hours. 2、Instllation sites altitude above sea level does not surpass 2000m. 3、Atmospheric relative temperatures does not surpass 50％ when the surrounding air temperature are 40℃,Can not have a higher relative humidity in a lower temperature,In the wettest month monthly average most low tem perature is +25℃,the monthly average maximum relative is 90％.and consideration the dew on product surface.Because of the temperature change 4、tnstallation sites environmental pollution can be 3 levels. 5、Install category is III kind. 6、Install condition:A.Installment gradient with vertical not to surpass 5°　B.Installs in without remarkable\vibration and impact place.

	四、技术要求 Specification 1、L1.L2.L3:三相电源输入 2、T1、T2、T3：三相电源输出接电动机 3、虚线杠内为压缩机设备 4、P：压力传感器“用户自备” 5、P1、P2：压力传感器（P）同00-097.98间接连线“用户自备” 6、S：自锁按钮 1、L1.L2.L3:Three-phase power input 2、T1、T2、T3：The three-phase power outputs contact the motor 3、In the dashed line is the compressor equipment 4、P：The pressure transmitter"the user supplise for oneself" 5、P1、P2：The pressure transmitter（P）"is the same as 00-097.98 indireatly connecting 6、S：Locking push button
	五、订货须知 Ordering notes 　　订货时请注名型号，规格等，例：QCX5-32/380V.11kw.50Hz.50台 　　Please make sure the model,specification etc.Wen makethe order.For example:QCX5-32/380V.11kw.50Hz.50pcs